horntools Quick Fist 25-57 mm (2 pcs.)

Quick Fist Original Tool Holder. This tool holder is ideal for items with a diameter of 25 - 57 mm. Each holder has a reliable load capacity of 11 kg; when used as a set, the load capacity is 22 kg. The tool holders are easy to mount, and the mounting surface of the holder is 64 x 19 mm. The plastic has been tested according to AfPS GS 2015:01 PAK and is suitable for long-term skin contact. Mounting: Use a #10 bolt or screw for fastening. Do not overtighten. The Quick Fist tool holder can be mounted in any direction. To tighten, simply clamp the tool between the jaws. Then press the strap with both thumbs and tighten it accordingly. For special applications, such as roof racks with round tube frames, you can mount the tool holder using hose clamps. Make sure that the hose clamp is on the plastic washer to avoid damaging the rubber tool holder. For small diameter items: Without the strap, press one jaw into another and then tighten the strap over it. Quick Fist can also be used as a pipe holder (especially suitable for boats). Do not use for exhaust pipes. For High Lift Jacks: For best results, mount three Quick Fist holders evenly along the steel tube of the jack. Drill a 12 mm hole in the Quick Fist holder. Use a 65 mm long 10 mm bolt to fasten the holder (see image). To mount the jack, hold it parallel to the three holders. Place the end of the jack into one of the Quick Fist holders, with the bolt through the steel tube, then loosely close the holder. Then place the steel tube into the other two holders. Once all three holders support the jack, the holders can be properly secured. Note: A new Quick Fist tool holder fresh from the factory may be stiff. Open the jaws vertically with both hands and pull on each one once or twice. Close the jaws and loosen and fasten the strap a few times. Now you can mount the tool holder. If the Quick Fist tool holder is used for items where the maximum opening extent is necessary, the holder will not work by hand. The holder must be mounted on a solid surface so that the rubber can stretch properly. Scope of delivery: 2x Quick Fist Original Tool Holders