horntools Quick Fist 70-381mm XL Tool Holder 2 pcs.

This tool holder consists of two straps. These straps are each 356 mm long and can accommodate round objects up to 381 mm in diameter. In linear measurement, even equipment up to 711 mm can be accommodated. Each holder has a reliable load capacity of 68 kg and the breaking load is 176 kg. Two holders can carry 136 kg, with a breaking load of 272 kg. The tool holders are easy to assemble and the mounting surface of the holder is 51 x 51 mm. The plastic has been tested according to AfPS GS 2015:01 PAK and is suitable for long-term skin contact. Assembly: The two parts of the holder must be assembled so that each side is aligned as shown, with the arrows on the bottom of each side pointing towards each other. Use #10 bolts or screws and corresponding washers to secure each base. Do not overtighten. If you want to secure a cylinder, make sure the base rests on a supporting surface or pad. Alternatively, angle irons or wooden blocks can be used (see illustration). This makes it easier to tighten the straps with both hands. Mount the base so that the strap is parallel to the outer edge of the item to be secured. The "ladder" section of the holder can be stretched by about 25 mm by pulling on the strap (NOT the ladder "rungs" or webs). To transport a cylinder, tighten the strap by pulling the "clamping jaw" part through the narrowest "ladder" section and then the two halves in opposite directions. If you want to secure a rectangular piece of equipment, you must firmly press on the "ladder" section while the "clamping jaw" part must be held flat. Scope of delivery: 2x Quick Fist Tool Holder